Integrated IP65 Vibration Meter Switch Vibration Transducer Output 0-5v

Integrated IP65 Vibration Meter Switch Vibration Transducer Output 0-5v

Overview

Integrated vibration switch, it is design to integrated by acceleration sensor, integrator,transduce and relay. Output 0-5V vibratory acceleration peak value or effective speed, and corresponding to the two touch spots of II level alarm.

Integrated vibration switch is easy to install,it is use together with panel meter, DCS, PLC etc. monitoring system of spot.

Technique specification

1. Transverse sensitivity: <5%

2. Shell electrical isolation

3. Measure parameter: velocity or acceleration, virtual value or acceleration peak value

4. Measure range optional: Max 180 ms-2 Or200mm/s

5. Vibrating value voltage outpute: 0-5V

6. Frequency Response:

10-1000Hz(velocity,5% accuracy)

1-1000 Hz(acceleration,5% accuracy)

7. Working tempreture (℃): -20～70；

8. Power supply: 24Vdc；

9. Alarm level: 2

10. Alarm output: relay touch spot on each level(normally open or close optional)

11. alarm value adjustable

12. Cable socket Model:(SY)X12KX3P

13. Case material: aluminum, sealed

14. Extraction: sideway

15. Protect grade: IP65

16. Sensor install: M8 x 1

17. size:Ф40 x 80 mm

18. weight: 250g

Connection method

Attention

1. Sensor and the object that under test should be closely connected. surface should be smooth, Sensor is installed by washer
2. For prevent loose and water vapor entrance, after the cable socket and sensor socket tighten could smear silicon rubber
3. For avoid the interference from earth wire, terminals of the transducer and the case is isolated. Please notice don’t shot out